Rear seat installation bolt identification.

[TheCommanderSim]

Hi All,

I am trying to identify the screw/bolt/fasteners used to attach the rear passenger seats to the fuselage.

I have identified the four fasteners at the front of the seat assembly, but the IPC doesn't show any of the fasteners at the rear of the base frame.

Could anyone advise?

Thank you

 

[Commander91gm]

That's probably because the two outer bolts Are actually luggage tie downs . I'm sure you could find bolts That would hold The seat In place Without the luggage Loops . I'm attaching a picture that I picked up from an Old Post That might help .

 

[TheCommanderSim]

Hi Joel,

Yes exactly these bolts. Any idea where they are in the Parts Catalogue or where I can get the part number to trace the size/spec?

Thanks

 

[Commander91gm]

Item 56 View attachment 1 Parts Manual_112_B_TC_TCA_IPC.pdf

 

[TheCommanderSim]

Thanks, Joel.

Much appreciated. Now to try and identify the thread spec.

Best
Richard

 

[Commander91gm]

It is a standard thread but I would have to pull one out to get the actual spec - no where near the plane.
Standard thread - I would think that you can try a couple of sizes. The hole in the frame limits the size bolt that will fit.
If it is any help it is slightly smaller that the hole and the frame and fits snug.

 

[Commander91gm]

Cross references to this

 

[TheCommanderSim]

Wow, Joel you are a wizard. Google came up with very little when I searched. Thanks!