I am sending you this privately as I do not want to post it on the site. The Lycoming part is close to $1,000 dollars for that rod end (no typo there).
It is a stainless rod end and should never be lubricated.
I am using the attached.
Only caveat is that the through bore is Metric and slightly smaller than the bolt.
A minute or so with a Dremel and a round diamond bit opens it up to the proper size.
https://www.ametric.com/product/39459/cfr-3-t-ss
It is a stainless rod end and should never be lubricated.
I am using the attached.
Only caveat is that the through bore is Metric and slightly smaller than the bolt.
A minute or so with a Dremel and a round diamond bit opens it up to the proper size.
https://www.ametric.com/product/39459/cfr-3-t-ss